Traffic Redirect - ZyXEL Communications Prestige 660W Series User Manual

LABEL
PPPoE +
PPPoE_Client_PC
(PPPoE
encapsulation only)
Subnet Mask
(ENET ENCAP
encapsulation only)
ENET ENCAP
Gateway
(ENET ENCAP
encapsulation only)
Back
Apply
Cancel

7.10 Traffic Redirect

Traffic redirect forwards traffic to a backup gateway when the Prestige cannot connect to the Internet. An
example is shown in the figure below.
WAN Setup
Table 7-1 WAN Setup
In addition to the Prestige's built-in PPPoE client, you can enable PPPoE pass through
to allow up to ten hosts on the LAN to use PPPoE client software on their computers to
connect to the ISP via the Prestige. Each host can have a separate account and a
public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not
appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP.
Enter a subnet mask in dotted decimal notation.
Refer to the Subnetting appendix on how to calculate a subnet mask If you are
implementing subnetting.
You must specify a gateway IP address (supplied by your ISP) when you select ENET
ENCAP in the Encapsulation field
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Prestige 660W/HW Series User's Guide
DESCRIPTION
7-9