Table of Contents
Advertisement
2.2 Satellite List
1. Press PR+, PR- keys to select the sa-
tellite up or down. Press OK key to se-
lect and mark, and you can press OK
key again to cancel the selection and
the mark.
2. If there is no satellite, the red colour
and blue colour keys will be invalid.
3. Press red colour key to pop up the
Edit Satellite window. Press PR+, PR- keys to
move cursor up or down.
Name: User numeric keys to change the name of the satellite, please refer to the
Edit Channel Name.
Longitude: You can press
longitude. After pressing OK key, you can use numeric keys to edit the longitude,
press EXIT key or the PR+, PR- keys to exit editing mode. The range of the longitude
is from 1to 180 degree. If beyond this range, system will inform you "out of range"
when you press yellow colour key on the RCU.
After setting, press yellow colour key to save and exit, while press blue colour key
to exit without saving.
4. Press green colour key to pop up the Add
Satellite window. Since the same operation as
the above Edit Satellite window, here we don't
explain any more.
5. Press blue colour key to pop up the
dialogue "Are you sure to delete?". Se-
lect Yes button and press OK key to
delete the selected satellite. You can
cancel this operation by pressing OK
key at the NO button.
keys to switch between east longitude and west
2.3 Antenna Setup
Part A: Fixed
Suppose that you have selected Fixed Antenna in the Antenna Connection window.
1. Satellite: All selected satellites in the satellite
list are displayed in this item.
Press
keys to select the satellite in cir-
cle. Or press OK key to pop up the drop-down
list, then select the desired satellite in the list
and press OK key to confirm.
2. LNB Freq, Transponder, DiSEqC1.0, Di-
SEqC1. 1 : The same operation as the above.
3. 22K, 0/12V, Polarity: You can press
keys to select in circle.
Part B: Motor
Suppose that you have selected Motor An-
tenna in the Antenna Connection window.
1. LNB Type: Select the proper LNB type.
2. Motor Type: Select between DiSEqC1.2 and
USALS. If you select DiSEqC1.2, the following
Local Longitude and Local Latitude items will
turn grey.
3. Delete All: Press OK key to pop up the dialo-
gue "Are you sure to clear set satellite position
of this tuner?". Press OK key at the Yes button
to clear all the memories about the position of
the satellites that are connected to the cu-
rrent tuner.
4. Motor Setting: Press OK key to the Motor
Setting window.
Satellite: Press
keys to select the sate-
llite in circle. Or press OK key to pop up the
drop-down list, then select the desired satellite
in the list and press OK key to confirm.
DHTS 4022A
ENGLISH
9
Advertisement
Table of Contents
