Manual Operation; Turn Off Gas To Appliance - Optal Clear 40 Installation & Operation Manual

OPERATING INSTRUCTIONS
▪ Set the minutes by pressing the (small
Setting P1 OFF Time
▪ press SET button to scroll to set-
ting P1 OFF time. P1
▪ Set the hour by pressing the
▪ Set the minutes by pressing the
Setting P2 ON Time
▪ press SET button to scroll to setting P2 ON time.
P2
▪ See instructions SETTING P1 ON TIME.
Setting P2 OFF Time
▪ press SET button to scroll to setting P2 OFF
time. P2
▪ See instructions SETTING P1 OFF TIME.
▪ This concludes programming Timers P1 and P2. Press
OFF or wait. The handset will automatically save your
changes.
APPENDIX B

MANUAL OPERATION

(Only possible, when MANUAL knob is used)
Access to the pilot burner is only required for ignition
with a match.
When turning main valve knob, do not force. Knob has
a slip clutch that clicks until the end stops are reached.
as adjustment to pilot standby position.
1. STOP! Read the safety information included before
(moon) is dis- proceeding.
2. Turn main valve knob to the OFF, full clockwise
position.
3. Turn MANUAL knob to the MAN, full clockwise
position.
4. Place ON/OFF switch (if equipped) in O (OFF posi-
(large tion).
5. W
no gas is in the area around the appliance, includ-
"WHAT TO DO IF YOU SMELL GAS" in the safety
information on page 2. If no gas is present, pro-
ceed to step 6.
6. Place ON/OFF switch (if equipped) in I (ON posi-
tion).
7. With the MANUAL knob in MAN position a manual
pilot valve operator and piezo ignitor (optional) are
accessible.
8. Fully push down manual pilot valve operator and hold
tinuing to hold in the manual pilot valve operator for
about one (1) minute after the pilot is lit. Release
manual pilot valve operator. If pilot does not stay lit,
Ignition with piezo ignitor:
Change the ignition cable from the receiver to the
valve
minutes and repeat.
If the pilot does not stay lit after several tries, turn
the gas control knob (main valve knob) to OFF and
proceed to step 12.
9. If applicable, replace pilot access panel before pro-
ceeding.
10. Turn MANUAL knob to the ON, full counterclockwise
11. Turn main valve knob to the full ON, full counter-
clockwise
12. If the appliance will not operate, follow the instructions
"TURN OFF GAS TO APPLIANCE" (page 21).
20 / 65
FOR OEM USE ONLY
If you detect gas STOP! Follow
I g nition with match:
I m mediately light the pilot with a match, while con-
page 21). Push in the piezo ig-
position.
position.
A p p e n d i x B