To Open And Close Solenoid Valve/Burner; Light/Dimmer Operation; Circulating Fan Operation - Optal Clear 40 Installation & Operation Manual

OPERATING INSTRUCTIONS

TO OPEN AND CLOSE SOLENOID VALVE/BURNER

NOTE: The latching solenoid valve cannot operate
manually. If the battery runs down it will remain
in the last operating position. During normal
operation the solenoid valve will be reset to
the ON position when the GV60 is switched
OFF remotely.
▪ Upon ignition Main Burner and Decora-
tive Burner are ON.
▪ Simultaneously press SET and (small
flame) buttons to switch the Burner
OFF. Printed instructions are on the
▪ Simultaneously press SET and
Burner OFF
ON. (The AUX symbol on the display
indicates the solenoid valve is OPEN.)
NOTE: The operation of the AUX is
blocked in timer OFF mode,
when the setting of the
Nighttime Setback Temperature
is "
Burner ON
Figure 24: Instructions for Latching Solenoid Valve (on battery cover)
APPENDIX B
".
17 / 65

LIGHT/DIMMER OPERATION

– Light/Dimmer
▪ B
(light bulb) mode. Light bulb icon
▪ Press and hold
turn ON the light or increase brightness.
▪ Press and hold
to decrease brightness.
▪ In the Light/Dimmer mode, the OFF
button shuts OFF the light.
▪ I
press and hold the
NOTE: The light bulb icon is displayed during light/dim-
mer setting only. 8 seconds after the light/dim-
mer has been set, the handset will automatically
go into temperature control mode (CSA version)
or manual mode (CE version).

CIRCULATING FAN OPERATION

– Circulating Fan
The circulating fan has 4 speed levels from low (1 bar)
to high (4 bars).
▪ press SET button to scroll to
(fan) mode. Fan and Level icons
▪ Press
ON and increase fan speed.
▪ Press
crease fan speed. To turn OFF fan,
press
4 speed level bars disappear.
NOTE: 8 seconds after the fan has been set, the
handset will automatically go into temperature
control mode (CSA version) or manual mode
(CE version). The fan starts 4 minutes after the
gas opens (from OFF or from pilot) at maximum
speed and goes to the displayed level after
10 seconds. The fan stops 10 minutes after the
gas is OFF or at pilot.
FOR OEM USE ONLY
A p p e n d i x B
-
-