Getting Ready - Bissell 19404 SERIES User Manual

Operations

Getting ready

The mop pad may have already come
attached to the mop head, if not follow
steps 1a and 1b below.
1. Add Freshening Disc and attach mop pad
a. Insert Spring Breeze Freshening Disc
into pocket inside mop pad. Use the
whole disc for a refreshing scent or cut
in half for a lighter scent.
b. Set mop head in mop pad, making sure
quick-grip release tab is located on the back.
2. Fill the water tank
a. Remove tank by lifting straight up
and away from unit.
b. Unscrew cap at bottom of water tank.
c. Fill water tank with water. For best results,
water should be at room temperature.
d. Replace the cap, tighten until snug.
e. Replace water tank by gently sliding tank
into place and press down firmly.
3. Twist the Quick Release™ cord wrap
clockwise to unwrap the power cord completely
and plug into a 120-Volt outlet as described on
the Important Safety Instructions, page 3.
4. SmartSet™ Steam Select Indicator light will
glow when the steam mop is ready to use. Press
the Steam Level button to choose the level of
steam you desire.
NOTE: Upon first use of the PowerFresh®
Pet Steam Mop or first use after refilling the
water tank, the pump may make a "knocking"
sound. This is normal and should only last a
few seconds.
WARNING
Never put descaling, alcoholic, or detergent products
into the steam cleaner, as this may damage it or make
it unsafe for use.
1a.
2a. 2b.
Tip
» Use of distilled water is
recommended to prolong
the life of your hard floor
cleaner.
www.BISSELL.com
1b.
7