Advertisement
Quick Links
Kit No. GK62-00002-0070
Document No. M051-00K62-A199
How To Install the Rocker Arm Kit
Tools required: Phillips screwdriver, T-45 Torx wrench, 4½ mm Allen wrench, snap ring tool
Estimated time required: 1 hour (to install both rocker arms) plus Loctite curing time (30 minutes)
KIT CONTENTS
Rocker arms (2)
Metal thrust washers (2)
Oilite washers (4: 2 thick, 2 thin)
Snap rings (2)
Loctite #620 (2 tubes)
Alcohol wipe (1)
PROCEDURE
1.
Remove the outer deadshaft covers.
2.
Disconnect the heart rate cable.
3.
Remove the user arm (see Figure 1).
4.
Remove the lower rocker arm cover (see
Figure 2).
5.
Separate the rocker arm from the pedal.
Fig 1: removing the user arm
Fig 2: separating the pedal from the rocker arm
08 Sep 2008
Advertisement
Related Manuals for Life Fitness Rocker Arm Kit
Summary of Contents for Life Fitness Rocker Arm Kit
- Page 1 Kit No. GK62-00002-0070 Document No. M051-00K62-A199 How To Install the Rocker Arm Kit Tools required: Phillips screwdriver, T-45 Torx wrench, 4½ mm Allen wrench, snap ring tool Estimated time required: 1 hour (to install both rocker arms) plus Loctite curing time (30 minutes)
- Page 2 Kit No. GK62-00002-0070 Document No. M051-00K62-A199 Remove the rocker arm from the deadshaft (see Figure 3). Discard all of the old hardware (Oilite washer, thrust washer, snap ring). Loosen and push the shaft collar all the way onto the deadshaft (see Figures 4 and Inspect the deadshaft for smoothness.
- Page 3 Kit No. GK62-00002-0070 Document No. M051-00K62-A199 The kit contains Oilite washers in two thicknesses. Slip one of the thinner Oilite washers onto the deadshaft as shown in Figure 6. 10. Wipe the deadshaft with the supplied alcohol wipe. Save the wipe; it will be used later in this procedure and during the second rocker arm installation.
- Page 4 Kit No. GK62-00002-0070 Document No. M051-00K62-A199 13. Rotate the rocker arm back and forth while sliding it onto the deadshaft (see Figure 9). This will spread the Loctite evenly onto the deadshaft. 14. Wipe off any excess Loctite near the snap ring groove with the alcohol wipe.
- Page 5 24. Reattach the outer deadshaft cover. 25. Repeat steps 1-23 with the other rocker arm. The Loctite on the first side will be curing while the second rocker arm kit is being installed. 26. Allow the Loctite on the second rocker arm kit to cure undisturbed for at least 30 minutes.