Hardware Installation And Service Issues; Notes For Power-On After Power-Off; Specific Issues And Workarounds - Fujitsu SPARC M4000 Product Notes

Hardware Installation and Service Issues

This section describes hardware specific issues and workarounds.

Notes for power-on after power-off

Please wait at least 30 seconds before turning on the system power that you turned
off, by pulling out the power cable or using the circuit breakers on the distribution
panel.

Specific Issues and Workarounds

TABLE 1
Hardware Issues and Workarounds
TABLE 1
CR ID Description
6433420 The domain console might display a Mailbox
timeout or IOCB interrupt timeout error during
boot.
6488846 During boot, the domain console might display
a checksum error for the SG(X)PCI2SCSIU320-
Z SCSI controller I/O card.
6498780 On the SPARC Enterprise M4000/M5000
servers, the OpenBoot PROM (OBP) might not
detect the on-board disk (HDD) boot device.
Performing a boot disk results in a console
message:
Can't locate boot device
6 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1060 • February 2008
lists known hardware issues and possible workarounds.
Workaround
Issue a reset -all command from the
OpenBoot PROM (OK) prompt and reboot.
Check for the availability of the latest
controller card firmware.
The PCI or PCI-X plug-in adapter card might
not be seated correctly. Reseat the card in slot 0
of the IOU.