Fujitsu SPARC M4000 Product Notes page 41

Upgrading From XCP104x to XCP 1050 or Later
The following steps describe the case of upgrading to XCP1060.
Note – LAN connections are disconnected when the XSCF resets. It is recommended
to use the XSCF serial connection to simplify the XCP upgrade procedure.
1. Log in to the XSCFU on an account with platform administrative privileges.
2. Verify that there are no faulted or deconfigured components by using the
showstatus(8) command.
XSCF> showstatus
The showstatus(8) prompt will return if there are no failures found in the System
Initialization. If anything is listed, contact a certified service engineer. before
proceeding.
Note – Take information with using BUI or snapshot(8) command. This will be
help in case any problem occurred in this procedure.
3. Power off all domains.
XSCF> poweroff -a
4. Confirm that all domains are stopped:
XSCF> showlogs power
5. Move the key position on the operator panel from Locked to Service.
6. Collect an XSCF snapshot to archive system status prior to upgrade.
XSCF> snapshot -t user@host:directory
7. The BUI can be used to upload the XCP 1060 upgrade image.
SPARC Enterprise M4000/M5000 Servers Product Notes 31