Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Axkid Duofix
Summary of Contents for Axkid Duofix
- Page 1 Instruction manual Duofix Rear-facing 9-18 kg Forward facing 9-18 kg installed with ISOfix with internal harness Rear-facing 9-25 kg Forward facing 15-25 kg installed with vehicle seat belt as a booster seat using vehicle seat belt Tested and approved according to...
-
Page 2: Important Information
Do not use a child restraint in a seating position where an active airbag is fitted. If you still wish to install the Duofix in this location the airbag must be disconnected at an authorised service centre. - Page 3 This child restraint can be installed in four different ways depending on your child’s age and size. A description of the Duofix’s different parts can be found on next page. On the following pages you will find instructions on how to install your Duofix.
- Page 4 1.Top seat belt guide for forward facing 10.Upper tether/anchorage straps installation 11.Support leg 2.Adjustable Headrest 12.Adjustors for support leg 3.Seat belt guide in headrest (for use for- 13.Heels ward facing as a booster seat) 14.Adjustor for ISOfix 4.Internal harness 15.Lock-off 5.Lower seat belt guide (for use forward 16.Pocket for storage of instruction manual facing as booster seat)
- Page 5 Placing the child restraint The easiest way to lift the Duofix into the ve- hicle is with its back first. To begin push and hold the adjustor for ISOfix(1). Now you should be able to unfold the ISOfix arms (2).
- Page 6 Please note that once the installation of the Duofix is com- plete, it will be somewhat more reclined as it sinks into the vehicle’s seat when tight- ening seat belts and tether straps.
- Page 7 Continued on next page...
- Page 8 Continued on next page...
- Page 9 When installing Duofix in the front passenger seat the tether straps must be attached to the front gliding tracks so the tether points will be located along the front edge of the passen- ger seat. Pull out the upper anchorage strap from the belt housing (7) to an appropriate length.
- Page 10 If you have installed Duofix in the back seat you can now move the front seat to a com- fortable position. The back of the child re- straint can, but is not necessary, be in con- tact with the back of the front seat.
- Page 11 Important to remember Do not use a child restraint in a seating position where an active airbag is fitted. If you still wish to install your Duofix in this location the airbag must be disconnected at an authorized service centre. Some...
- Page 12 Bear in mind that once the installation of the Duofix is complete, it will be somewhat more reclined as it sinks into the ve- hicle’s seat from tightening seat belts and tether straps.
- Page 13 anchoring point needs to be as close to the floor as possible. In doing so you you should always insert the buckle through the closest appropri- ate slot in the strap tp create a slip knot then pull tight. This needs to be repeated on both sides to create two anchor points.
- Page 14 If you have installed Duofix in the back seat you can now move the front seat to a comfortable position. The back of the child restraint can, but is not necessary, be in con- tact with the back of the front seat.
- Page 15 Step 2 agonal belt through the top seat belt guide (2) located at the top side of the Duofix. Then feed the seat belt behind the child restraint vertically down to the closest seat belt slot in the seat back (3). (The lap section of the seat belt is simultaneously guided into the same slot).
- Page 16 This line should be sible to get the headrest into a locked po- hidden by the seat cover sition, Duofix should instead be used as a after adjusting harness booster seat. (See page 18-19). To release the harness, push the har-...
- Page 17 Parking brake on headrest The headrest on your Duofix is equipped with a parking brake. To activate the parkingbrake, pull the harness until the headrest is at desired height, you will hear a “click” sound from the headrest as it...
- Page 18 Do not use a child restraint in a seating position where an active airbag is fitted. If you still wish to install Duofix in this location the airbag must be disconnected at an authorized service centre. Some vehicles may be equipped with a switch which allows you to man- ually switch the airbag off.
- Page 19 If adjustment is need- ed, press the Recline adjustment lever (4) and push on restraint until completely Step 1 upright. Now your Duofix is ready to be used as a booster seat. Installation in vehicle Step 2 Place the Duofix child restraint onto the vehicle seat, then place your child into the restraint.
- Page 20 On www.axkid.com you could find videos explaining how to deattach and attach the clothing. Any plastic parts of Duofix can be cleaned with mild detergent and water. Do not use aggressive chemicals containing solvents etc, as this can cause damage to the plastic and compromise the safety of the child restraint.