Assembly - Ariens SNO-THRO 938016 - 522 Owner's/Operator's Manual

TOOLS REQUIRED
• 7/16" Open-end wrench
TO REMOVE UNIT FROM CARTON
1. Cut off top of carton.
2. Remove front and rear inserts and literature pack.
3. Cut out back of carton and roll unit out.
4. Remove protective packaging materials.

ASSEMBLY

Handlebar Assembly
1. Remove retaining nuts and handlebar knobs and
release J-bolts from lower handlebar.
2. Unfold upper handlebar.
Adjust handlebar to a height comfortable for the
NOTE:
operator. Refer to Handlebars in Operation.
3. Put J-bolts through the upper handlebar and lower
handlebar holes.
4. Replace retaining nuts and tighten handlebar
knobs to secure upper handlebar.
ASSEMBLY
6
2
1. Lower Handle Bar
2. Upper Handle Bar
H a
r d w
L i t
a r e
e r a
3. J-Bolt
/
t u r
P a
e
c k
4. Knob
Discharge Chute Assembly
4
1
OS1510
1. Discharge Chute
2. Rear Screw and
Nut
1. Remove screw and nut from rear of discharge
chute.
2. Tip discharge chute up and install hardware just
removed. Tighten hardware at rear of discharge
chute first, then sides.
CHECKLIST
Please complete the following checklist before
proceeding:
❑
All assembly instructions have been completed.
❑
No remaining loose parts in carton.
❑
Handlebar is adjusted comfortably and tightened
securely.
While learning how to use your unit, pay extra
attention to the following important items:
❑
Fill fuel tank with proper gasoline/oil mix.
❑
Become familiar with all controls – their location
and function.
❑
Be certain that all hardware is properly tight-
ened.
GB - 8
1
5
7
5. J-Bolt Holes
6. Auger Clutch Bail
7. Retaining Nuts
2
3
3. Side Hardware
4. Chute Handle
4
3
OS1530
OS1520