Assembly - Ariens Sno-Thro ST520E Owner's/Operator's Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping over
boxed unit could result in personal
injury or damage to unit.
PACKAGE CONTENTS
2
4
1
1. Sno-Thro
Unit
2. Discharge
Chute
Figure 3

ASSEMBLY

Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper
wing knobs on the handlebar assembly.
2. Loosen the wing nuts on the shift rod.
3. Put the speed selector lever in the sixth
forward position.
4. Rotate the handlebars into operating
position.
ASSEMBLY
3
OS8020
3. Chute Rod
4. Literature
Pack with
Extra Shear
Bolts
5. Install and tighten all wing knobs and
wing nuts on the handlebar assembly
and shift rod.
.
2
3
1. Shift Rod
2. Wing Knob and Bolt
3. Wing Nut and Bolt
4. Handlebar
Install Discharge Chute (Figure 5)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from the
bottom of the chute pedestal.
3. Install discharge chute over opening in
the auger housing and secure pedestal
to auger housing with hardware
removed in step 2.
GB - 8
1
Figure 4
4
OS8025