Advertisement
Operation:
1, Dimming Mode
To enter the dimming mode, press the "MODE" button to show "DIMMER" on the LCD display. Now press
the "ENTER" button and use the "UP" and "DOWN" buttons to set the brightness from 00-99.
Now press the "ENTER" button again to add strobe and use the "UP" and "DOWN" buttons to change the
flash speed from 00-99.
NOTE: C:99 = Dimming (00 = off, 99 = full on), F-99 = Flash (00 = off, 99 = fast)
When you are happy with your choice, press the "ENTER" button to confirm it.
2, Slave Mode
To enter slave mode, press the "MODE" button to show "SLAVE" on the LCD display. Now the unit will follow in
sequence with the master unit.
3, Dimming Curve Mode
The LED Zoom includes two sets of dimming curves.
The first is a Halogen emulation mode with a very smooth slow dimming and a small delay.
The second is an LED response with faster dimming and no delay.
To enter the dimming curve mode, press the "MODE" button to show "DIMMER CURVE" on the LCD display.
Now press the "ENTER" button and use the "UP" and "DOWN" buttons to select between the 4 dimming
curves from 01-08.
1-4 are for halogen response type : 01 = Linear,
5-8 are for LED response type :
When you are happy with your setting, press the "ENTER" button to confirm it.
LINEAR: the increase in light intensity appear to be linear as DMX value is increased.
SQUARE: light intensity control is finer at low levels and coarser at high levels
INVERSE SQUARE: light intensity control is coarser at low levels and finer at high levels
S-CURVE: light intensity control is fine at low levels and high levels and coarser at medium levels.
4, Channel Mode
To enter the channel mode, first press the mode button to show "CHANNEL" on the LCD display. Now press
the "ENTER" button and use the "UP" and "DOWN" buttons to select 1 or 3 channel mode.
5, DMX Mode
To enter the DMX mode, press the "MODE" button to show "DMX MODE" on the LCD display. Now press the
"ENTER" button and use the "UP" and "DOWN" buttons to select the DMX address from 001-512.
When you are happy with your setting, press the "ENTER" button to confirm it.
DMX Charts
1 channel mode:
Channel
Value
CH1
0-255
02 = Square,
05 = Linear,
06 = Square,
Dimming 0-100% using the curve set on the fixture
4
03 = Inverse square,
07 = Inverse square,
Function
04 = S-curve.
08 = S-curve.
Advertisement
