Delta CL120 Instruction Manual page 9

906992 - 08-10-02.qxd
Depending on room temperature,
line voltage, and existing charge
level, initial battery charging may
take longer than six to eight hours.
Disconnect charger from power
source when not in use.
INSTALLING OR REMOVING
BATTERY PACK
TO REMOVE
Depress the battery release button
(B) Fig. 7, and pull battery pack out of
tool.
TO INSTALL BATTERY PACK: Align
rails (A) Fig. 7, on the tool with the
four tabs on the battery pack, and
push battery pack onto tool until it
locks in place.
HOW TO HOLD THE
DRILL/DRIVER
WARNING: The front end of the
Drill/Driver may be made live if the tool
drills into live wiring in the wall. TO
PREVENT ACCIDENTAL ELECTRICAL
SHOCK, DRILL/DRIVER MUST BE
HELD AS SHOWN IN FIG. 8.
GENERAL DRILLING
1. Set torque adjusting collar for
drilling operation and set speed
selector to appropriate speed.
2. Be sure drill bit is securely gripped in chuck.
3. Set REVERSING BUTTON for clockwise rotation.
4. CAUTION: Make sure work is held securely in vise or clamped in place
prior to starting drilling operation. Loose work may spin and cause bodily
injury.
5. Locate exact center for hole to be drilled and using a center punch, make
a small dent in work.
6. Place tip of drill bit in dent made by center punch, hold drill square with
work, and start the motor.
7. CAUTION: Applying too much pressure may cause the bit to overheat or
break resulting in bodily injury or damaged drill bits.
Apply steady, even pressure to keep drill bit cutting. Too little pressure will
keep the bit from cutting and dull the cutting edges due to excessive friction
created by sliding over the surface.
CAUTION: Always be alert and brace yourself against the twisting
action of the drill.
8/9/02 4:07 PM Page 9
BATTERY PACK:
9
E
R
E
Fig. 6
A
B
Fig. 7
Fig. 8