Honda 1982 GL1100 INTERSTATE Owner's Manual page 53

r it
Do
4)
NOTE:
*
Do not depress the brake lever when
the wheel is off the motorcycle. The
caliper pistons will be forced out of the
cylinder with sUbsequent loss of brake
fluid. If this occurs, servicing of the
brake system will be necessary. See
your authorized Honda dealer.
Installation
I.
Lower the forks lightly so that the
hollows in the fork legs rest on top of
the axle.
CAUTION'
When installing the wheel, fit the brake
disc (7) carefully between the brake
pads to avoid damaging the pads.
2. Install the axle holders (5) with the
"F" arrow forward and hand tighten
the holder nuts (4) with Oat washers
and lock washers. Make sure the speed·
ometer cable gear box is horizontal.
3. Fit the brake caliper over the disc,
install the caliper bolts (3), and tighten
them to 30-40 N·m (3.0-4.0 kg-m,
22-29 ft-Ib) torque.
4. Tighten the axle holder nuts (4) on the
left axle holder (speedometer gearbox
side) to 30-40 N·m (3.0-4.0 kg-m,
22-29 ft-lb) torque, starting with the
forward nut.
5. Measure the clearance between the
outside surface of the right brake disc
(7) and the caliper holder (6) with a
0.7 mm (0.028 in) feeler gauge. If the
1C'
.;.
11
6
l-
7
~~
,--W
I
(6)Cahper holder
(7)
Disc
_________"'"""'z.-_