Suggestions For Improvements And Changes - Webasto Air Top 2000 ST D Service And Repair Manual

AIR TOP 2000 ST
authorized Webasto workshop. After this the heater
lock-out can be cancelled by switching it off and then on
again. If this action does not produce the required
success (if the heater overheats again) take it to a
Webasto-authorized workshop. Never remove the
grating over the air inlet of the heater.
The air outlet jets or air vents with adjustable flaps must
always be opened to some extent so that the air flow
through the heater is not completely blocked. At least
one air vent must be prevented from being closed.
If the heater is installed in a storage area, you must
ensure that no inflammable substances are kept in this
area and that other material does not restrict the air
supply to the heater.
Air lines must be securely fixed to the heater (using pipe
clips, for example) and all other connection points (for
example vents).
IMPORTANT! The errors described below are to
be avoided at all costs:
• Do not stand on the heater or place or throw any
heavy objects on the heater.
• Do not place any items of clothing, textiles or similar
materials over the heater or in front of the hot air
inlet side and hot air outlet.
• The flow of hot air from the heater must not be
restricted or blocked by highly inflammable
substances or materials such as rags, cleaning wool,
etc.
• Inflammable or explosive substances and gases must
not be placed near or in contact with the heater, the
hot air line, the flow of hot air or the exhaust pipe.
www.webasto.us
• The heater must not be cleaned with a high pressure
cleaner.
• Do not switch the heater off at the main battery
switch or battery isolation switch since otherwise it is
possible that it may suffer long term damage if it is
switched off frequently using the battery isolation
switch and this can cause damage and negative
influences on the function of the heater.
NOTE: Failure to follow the installation
instructions and the notes contained therein will
lead to all liability being refused by Webasto
The same applies if repairs are carried out
incorrectly or with the use of parts other than
genuine spare parts. This invalidates the type
approval for the heater and its homologation /
EC type permit.
You must read the operating manual before starting the
heater for the first time.
1.5 S
UGGESTIONS FOR
C
HANGES
Complaints, improvement suggestions or corrections
relating to this workshop manual should be addressed to
Webasto Product North America, Inc.
Technical Documentation Group
15083 North Road
Fenton MI 48430
Phone: 810.593.6000
Fax: 810.593.6001
3
INTRODUCTION
I
MPROVEMENTS AND
Webasto Product N.A., Inc.