Set Up - Zenoah LRT2300 Owner's Manual

6. Set up

MOUNTING ENGINE
1. Using attached 4 bolts, secure the connection firmly
with equal force.
INSTALLING HANDLE
Mount the handle to the shaft tube and clamp it at your
best operating position.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
CONNECTING THE SWITCH CORD
WARNING
• Insert the end of the cord firmly. An improper con-
nection may result in the cord becoming loose
during operation or in causing the engine to fail to
stop even after the switch has been turned off.
• Be careful never to bend the end of the cord when
connecting it.
1. Connect the terminal ends of the two cords on the
side of the engine to the terminal ends of the two cords
on the side of the trimmer. Note that no distinction is
made between positive and negative nodes, and that
the cords may be connected in any combination.
2. After the cords have been connected, use the clamp
located on the side of the engine cover to fix the ends
of the cords firmly into place.
(1) Clamp
ATTACHING THE TRANSMISSION
1. Remove the cap on the end of tube.
2. Remove the screw (4) temporary tightened into the
end of the transmission.
3. Insert the end of the tube into the transmission.
4. Line up the hole on the end of the transmission with
the screw hole (3) on the tube, and tighten the screw
(4) firmly.
5. Using a wrench, tighten the fastening bolt (5) firmly
to fix the transmission into place.
HARNESS
WARNING
ALWAYS WEAR THE PROVIDED HARNESS WHEN
USING THE MACHINE!
Always make sure the machine is hooked securely
to the harness.
If you don't, you will be unable to control the machine
safely. This can result in injury to yourself or oth-
ers.
Never use a harness with a defective quick release
or any other damage.
HOW TO WEAR
1. Wear the provided harness
without twisted bands, with the
hanger on your right side.
QUICK RELEASE
The harness is equipped with a "QUICK RELEASE"
devise.
To release the machine from the harness in emergency
situations, please follow the procedure as explained
below.
WARNING
Make sure to check proper working of the QUICK
RELEASE device BEFORE operating the machine.
Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your
left hand securely, press
both sides of the buckle.
BALANCE UNIT
1. Put on harness and attach unit to harness
2. Depending on the working posture, slide clamp up or
down until unit balances and the harness fits your
body.
LRT2300
(1) Tube
(2) Transmission
(3) Screw hole
(4) Screw
(5) Fastening bolt
(1)
(1) Hanger
(1)
(1) Buckle
GB-7
G
B