Zenoah LRT2300 Owner's Manual
  1. Manuals
  2. Brands
  3. Zenoah Manuals
  4. Trimmer
  5. LRT2300
  6. Owner's manual

Zenoah LRT2300 Owner's Manual

Long reach trimmer
Hide thumbs Also See for LRT2300:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's/operator's Manual
115 40 44-38 (012)
G
B
OWNER'S MANUAL
LONG REACH TRIMMER
LRT2300

Advertisement

Table of Contents
loading

Related Manuals for Zenoah LRT2300

Summary of Contents for Zenoah LRT2300

  • Page 1 115 40 44-38 (012) OWNER’S MANUAL LONG REACH TRIMMER LRT2300...

  • Page 2: Table Of Contents

    LRT2300 Contents SAFETY FIRST Instructions contained in warnings within this manual marked with a symbol concern critical points which must be taken into 1. Parts location ...........2 consideration to prevent possible serious bodily injury, and for 2. Specifications ...........3 this reason you are requested to read all such instructions care- fully and follow them without fail.

  • Page 3: Specifications

    Air-cooled 2-stroke gasoline Model Zenoah G23L Idle speed 3000±200min Displacement 22.5 Fuel Mixture (Gasoline 50 : Oil 1) (when using ZENOAH genuine oil) Carburetor Walbro Diaphragm type Spark plug NGK BPMR6A Fuel tank capacity 0.65 Transmission Centrifugal clutch, Spiral bevel gear, Cam crank Reduction ratio Specifications are subject to change without notice.

  • Page 4: For Safe Operation

    LRT2300 5. For safe operation steady posture. 1. Read this manual carefully b. At night, at times of heavy fog, until you completely under- or at any other times when stand and follow all safety and your field of vision might be operating instructions.
  • Page 5 2. Check the condition of working unit to your authorized ZENOAH area to avoid any accident by servicing dealer for repair. hitting hidden obstacles such as...
  • Page 6 5. For safe operation • IF SOMEONE COMES HANDLING FUEL 1. Guard against hazardous situa- 1. The engine of the ZENOAH prod- tions at all times. Warn adults to uct is designed to run on a mixed keep pets and children away fuel, which contains highly flam- from the area.

  • Page 7: Set Up

    LRT2300 6. Set up MOUNTING ENGINE ATTACHING THE TRANSMISSION 1. Using attached 4 bolts, secure the connection firmly 1. Remove the cap on the end of tube. with equal force. 2. Remove the screw (4) temporary tightened into the end of the transmission.

  • Page 8: Fuel

    6. Indicate the contents on outside of container for easy identification. ■ FUELING THE UNIT • The Zenoah engines are lubricated by oil specially 1. Untwist and remove the fuel cap. Rest the cap on a formulated for air-cooled 2-cycle gasoline engine use.

  • Page 9: Operation

    LRT2300 8. Operation NOTE STARTING ENGINE 1. When restarting the engine immediately after stop- IMPORTANT ping it, leave the choke open. 1. Rest the unit on a flat, firm place. Keep the cutting 2. Overchoking can make the engine hard to start due head off the ground and clear of surrounding objects to excess fuel.
  • Page 10 LRT2300 8. Operation Adjusting the angle of the cutting blades WARNING 1. Stop the trimmer engine. 2. Turn the clamp lever counter-clockwise to loosen • This product is equipped with extremely sharp blades, and when used improperly these blades 3. Adjust the angle of the blades to the desired angle...

  • Page 11: Maintenance

    • If a gap exists between the upper and lower blades, you should contact the authorized ZENOAH servic- follow the procedure below to adjust them so that ing dealer from which you purchased your ZENOAH they fit more closely together. trimmer to have the blades resharpened or re- • Loosen lock nut (A) as shown in the diagram.
  • Page 12 LRT2300 9. Maintenance 9. Maintenance SPARK PLUG WARNING • Starting failure and mis-firing are often caused by a fouled spark plug. Clean the spark plug and check Make sure that the engine has stopped and is cool that the plug gap is in the correct range. For a re- before performing any service to the machine.

  • Page 13: Storage

    LRT2300 9. Maintenance 10. Storage INTAKE AIR COOLING VENT • Aged fuel is one of major causes of engine starting failure. Before storing the unit, empty the fuel tank WARNING and run the engine until it uses all the fuel left in the fuel line and the carburetor. Store the unit indoor •...

  • Page 14: Troubleshooting Guide

    → consult with the repair specialty store cylinder fin, fan cover When your unit seems to need further service, please consult with our ZENOAH service shop in your area. Limited warranty Should any failure occur on the product under normal...

This manual is also suitable for:

Sht2300

Table of Contents