Autofloat Switches - Bayliner 265 Owner's Manual Supplemente

Chapter 6: Plumbing

Autofloat Switches

• The automatic bilge pumps use float (autofloat) switches to automatically turn On the pumps whenever water
rises to a preset level in the bilge.
• The autofloat switches are normally mounted next to the bilge pumps they control.
• The autofloat switches should be tested often as follows.
Autofloat testing:
1. Lift the float switch test button
up to turn On the bilge pump.
• If the pump does not turn On,
check the fuse on the fuse block.
• If the fuse is good but the switch
still doesn't work, it may mean
the switch is bad or possibly the
battery is low.
2. After testing, push the test but-
ton all the way down to return
the float switch to auto mode.
When the test is completed on each float switch, you MUST push the test button all the way
down to return the switch to auto mode!
38
LIFT SWITCH UP
BILGE PUMP SHOULD TURN ON
!
CAUTION!
265 • Owner's Manual Supplement
FLOAT SWITCH
TESTING
FLOAT SWITCH
TEST BUTTON
PUSH SWITCH DOWN
BILGE PUMP SHOULD TURN OFF