Map Orientation - Becker PROFESSIONAL 50 Operating Manual

>>> NAVIGATION MODE

Map orientation

When a route is activated, the map view
> D
can be oriented in different ways.
> GB
If you have selected a 2D view in the
Navigation settings in the map view (see
> F
page 64), this pertains to the compass
direction only.
> I
> Press the 2D map view on the display
> PL
a little longer.
Apart from the pulsating point, a
compass and two arrow buttons pointing
to the left and right appear on the top
edge of the screen.
> Press the
rotate the map towards the desired
compass direction.
94
You can orient the map for example in
the direction of travel.
If you have selected a 3D display for the
map view, the vertical display angle can
be adjusted, too.
> Press the 3D map view on the display
a little longer.
Apart from the pulsating point, a com-
pass and two arrow buttons
pointing to the left and right appear on
the top edge of the screen, and on the left
edge of the screen, two arrow buttons
pointing up and down are displayed.
and buttons to
> Press the
The viewing angle will be lower and the
horizon is moved back after a while into
the image.
> Press the
The viewing angle will be steeper. If the
angle is exactly 90°, you are viewing the
map in the 2D view from the top.
The Route overview
and
With the Route overview, you can have
Points of Interest (POIs) and, if the TMC
on route option is activated in the
Navigation settings > Route overview
button.
menu, TMC events displayed on the
selected route.
> Press the
A list of POIs and traffic events are
displayed. In the top edge of the screen,
four single buttons are displayed for TMC
announcements on the route and the
three selected POI Categories are also
displayed. Apart from the symbols, the
button.
button.