Table of Contents
Advertisement
FCC ID: O4GTRIP300
MADE IN CHINA
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTES:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE GUARANTEE OF THIS DEVICE COULD VOID THE
USER'S AUTHORITY TO OPERATE THE DEVICE.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or experienced radio / TV technician for help.
IC: 7666A-TRIP300
This device complies with Industry Canada RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference,including interference that may cause
undesired operation of the device.
Leprésent appareil est conforme aux CNR d'Industrie Canada applicable
aux appareils radio. Exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
meme si le brouillage est susceptible d'en compromettre le fonctionnement.
Hide quick links:
Advertisement
Table of Contents
