Sennheiser evolution D1 User Manual page 39

Using the products
Changing the gateway address
IP
Subnet
Gateway
Network
IPv6 1188:80F3:1388:...
MAC 00:1B:66:7D:56:D3
Subnet
Gateway
IPv6 1188:80F3:1388:...
Network
MAC 00:1B:66:7D:56:D3
Gateway
IPv6 1188:80F3:1388:...
MAC 00:1B:66:7D:56:D3
Network
Mode
WALKTEST
You can change the gateway of the receiver.
Select Network Settings – Gateway.
0.0.0.0.
0.0.0.0.
Enter the gateway address.
0.0.0.0.
Select Save and confirm by pressing the jog dial.
Displaying the IPv6 address
Select Network Settings – IPv6.
0.0.0.0
The IPv6 address is displayed, but it cannot be changed.
0.0.0.0
Press the
Exit
Displaying the MAC address
Select Network Settings – MAC.
0.0.0.0
The MAC address is displayed, but it cannot be changed.
Press the
Exit
Fixed IP
Performing a walk test (checking the reception quality)
The Walk Test menu item allows you to check the reception quality of your
radio links within the operating environment. By performing a walk test, you
can verify the range and coverage of the radio links.
Switch on the transmitters and receivers of all radio links that you want to
use. In addition, switch on all other devices that you want to use in the
operating environment.
Select Walk Test on all receivers that you want to use for the walk test.
The RF signal level display appears on the display panel of both the receiver
and the transmitter.
Walk the operating environment with one or several paired transmitters.
The RF signal level display on the display panel of both the receiver and the
transmitter is continuously updated.
Check the RF signal level display for more detailed information on the
reception quality:
- Good reception quality is indicated by a tick (
- If the tick is missing, reception quality is sufficient.
- If reception quality is or was compromised at any position, this is indi-
cated by a warning triangle ( ). The warning triangle remains displayed
on the display panel even if reception quality improves afterwards.
- If reception fails completely, the background of the display panel changes
back and forth between light and dark and No Link
play panel.
Press the
If the result of the walk test is not satisfying, you can take the following
remedial measures:
• If possible, reposition the receivers so that there is always a direct
line of sight between the receiving antennas and the paired trans-
mitter.
• If possible, remove obstacles between the transmitter and the
receiving antennas.
• When rack-mounting receivers, you should mount their SG4 rod
antennas to the front of the rack using the GA 4 rack-mount kit.
ESC button to return to the operating menu.
ESC button to return to the operating menu.
ESC button on the receiver to end the walk test.
).
appears on the dis-
37