Sennheiser evolution D1 User Manual page 20

Putting the products into operation
18
1
2 rack mount "ears"
2
1 blanking plate
3
1 jointing plate
4
2 R-SMA extension cables
5
Screw-in R-SMA sockets
6
R-SMA connectors with washers and nuts
7
2 blanking plugs for closing off the antenna holes in the blanking plate
8
2 recessed head screws
9
6 recessed head screws
Mounting a single receiver into a rack
1
Unscrew and remove the four screws located on the sides of the receiver
housing.
Secure the rack mount "ears"
viously removed recessed head screws (see right-hand diagram).
Make sure that the angled ends of the rack mount "ears" point forward.
Secure the blanking plate
two recessed head screws 8.
Make sure to use the correct side (the one with the round holes) of the
2
blanking plate to secure it to the rack mount "ear".
If you want to mount the supplied rod antennas to the front of the rack:
Read the next section.
If you do not want to mount the supplied rod antennas to the front of the rack:
Insert the two blanking plugs
Slide the receiver into the 19" rack.
Secure the rack mount "ears"
2
1
to the sides of the receiver using the pre-
2
to one of the rack mount "ears"
7
into the unused antenna holes.
1
and the blanking plate
7
1
using the
2
to the rack.