Automatic Dhcp Configuration; Fixed Ip Configuration - AMX IS-SPX-1000 Operation/Reference Manual

Automatic DHCP Configuration

To manually configure an IS-SPX-1000 to connect to a specific network using DHCP for the attribution of
network addresses:
1.
On the Network Settings page under the Basic tab, check the DHCP radio button.
2.
Validate the new network configuration by pushing the Update button.
3.
Re-enter the device's IP address to verify that the configuration is complete.
If the IS-SPX-1000 has been configured to use DHCP but the DHCP server cannot
be contacted by the device, you need to reinitialize the unit to its factory default and
restart the configuration procedure.

Fixed IP Configuration

To manually configure an IS-SPX-1000 to connect to a specific network with a fixed IP address:
1.
Get the information on the network to be reached. This includes a range of free IP addresses that can be
allocated to the IS-SPX-1000 without network conflicts and the correct subnet mask.
2.
On the Network Settings page under the Basic tab, check the Static radio button. This enables the Static
Network Settings fields.
3.
Enter a static IP address in the range of the free IP addresses of your network.
4.
Make sure that the subnet mask corresponds to your network configuration.
5.
Enter the other network parameters if known.
6.
Press the Apply button to validate the changes.
If the IS-SPX-1000 has been configured with an incorrect IP address, you need to
reinitialize the unit to its factory default and restart the configuration procedure.
IS-SPX-1000 Inspired Signage Xpress Player 23