AMX IS-SPX-1000 Operation/Reference Manual page 27

Administration - Display Settings - Advanced page
Display Settings:
Resolution:
Default aspect ratio:
Force standard video modes:
Restrict video mode to:
Power mode for VGA output:
HDMI supports underscan:
Overscan percentage:
Force vertical refresh:
Screen orientation
Enable audio output:
Interactivity Settings:
Enable events:
Maximum rendering latency:
Reduce latency to 60ms when
events are received:
Touchscreen Calibration:
Start Calibration Procedure:
Splash Screen Configuration:
IS-SPX-1000 Inspired Signage Xpress Player
This dropdown menu controls the screen resolution on the display.
Choose a specific resolution or between VGA, ED, or HD.
This dropdown menu controls the default aspect ratio on the display.
Choose between 4:3, 16:9, or 16:10.
Click this box to force the display into a standard video presentation
mode.
This dropdown menu controls the ability to restrict the video mode to
htmi, vesa, or gtf, or a combination of two of these.
In this dropdown menu, select between Automatic, Always Off, and
Always On.
Click this box if the HDMI display supports underscan.
This dropdown menu allows a selection of the overscan percentage,
ranging from zero to 5.
This dropdown menu controls the vertical refresh range in hertz: 24,
25, 30, 50, and 60.
This dropdown menu controls the screen orientation of the display.
If the display has audio capability, click this box to enable audio out-
put through the IS-SPX-1000.
Click this box to allow programmed events to be displayed.
This dropdown menu controls the maximum rendering latency of the
display in milliseconds. Select between 250, 500, 1000, and 1500
milliseconds
Note: increasing the rendering latency number will slow the 
rendering in the case of an event.
To speed performance, click this box to reduce the rendering latency
to 60 milliseconds when events are to be received by the display.
If the IS-SPX-1000 is connected to a touchscreen, the touchscreen
display may be calibrated from this interface.
• Use the text fields to enter manual coordinates, if necessary.
• Press the Apply button to save any manual changes.
NOTE: Pressing this Apply button will not affect any other changes
made on this page.
• Press the Return to Default button to return the calibration settings
to the factory defaults.
• If the device is connected to a touch screen, press the Start
Calibration Procedure button and follow the instructions on the
touch screen.
To choose a new splash screen file, press the Browse... button to
find and select the file and then press Apply to save it to the IS-SPX-
1000. A thumbnail of the new splash screen file will appear to the
right of the Browse... button. You may choose to change the boot,
shutdown, and firmware upgrade splash screens. If a new file is not
selected, then the current default file will remain in use. Press the
Reset to Default button to return all three settings to the originally
loaded default files.
NOTE: The Apply button at the bottom of this section will not affect
any other changes made on this page.
21