Plus/Minus Weighings; Parts Counting - KERN CB3K0.1N Operating Instructions Manual

7.5 Plus/minus weighings

For example unit weight control, fabrication control etc.
Switch-on the balance using the
Put the nominal weight on the weighing plate and tare to „0" using the
key. Remove the nominal weight.
Put the test objects subsequently on the weighing plate, the respective deviation from
the nominal weight is displayed with the respective sign to „+" and „-".
According to the same procedure also packages with the same weight can be
produced, referring to a nominal weight.
Back to weighing mode by pressing the

7.6 Parts counting

Switch-on the balance using the
Press key shortly. Appears the reference unit number 5.
By pressing the
be called up.
Place as many pieces to count on the weighing plate as the set reference quantity
requires.
Confirm with
The balance is now in parts counting mode counting all units on the weighing plate.
By pressing the
weight of the counted units.
Important: The larger the reference quantity, the more accurate the parts
counting.
Smallest counted weight see table „Technical data", if this weight is less, in the
display appears „Er 1". Use
The tare vessels can also be used for piece counting. Before starting percent
weighing use the
CB/FCB-BA-e-0640
key several times other reference quantities 10, 25 and 50 can
key.
key the balance returns to the weighing mode and displays the
key to return to the weighing mode.
key to tare out the container.
key and wait for the „0" display.
key.
key and wait for the „0" display.
15