Panasonic KX-TVP50 Installation Manual page 69

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
Screen output:
• The VPS tests the CPU card, the flash memory, and the
• Active ports are displayed on the screen.
Screen output:
The display will alert you if System Setup is not completed successfully.
Screen output:
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
Possible causes of the message: "DPT Interface Connection is not Established"
The PBX is not a correct type. Since the VPS is
configured to communicate with the KX-TA
series under APT Integration, this message will
always appear when connecting to another type
of PBX.
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected.
The PBX is a correct type but does not have the
proper software level to support APT/DPT
Integration.
The PBX is not programmed properly to support
APT/DPT Integration.
Installation Manual
Checking Flash Memory Cards.
Please wait...
PORT TEST...
SYSTEM SETUP
1... 2... 3...
ports until "1...2...3..." is displayed.
Active COs: 1 2
DPT Interface Connection is Established
** ON LINE MODE **
Active COs: 1 2
DPT Interface Connection is not Established
** OFF LINE MODE **
Cause
Table 16
Connect a correct PBX and set
the PBX type by using Quick
Setup (see Section 5
CUSTOMISING THE
SYSTEM).
Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
Consult your dealer or use
Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
Action
69