Panasonic KX-TVP50 Installation Manual page 63

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
CAUTION
Setting the DIP Switch to position 5 will default the Voice Processing System, resulting in a
loss of all user programming, and voice messages (except User1 and User2 prompts).
9.
Plug in and power up the VPS and wait approximately 2.5 min while the system initialises.
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "Checking Flash Memory Cards." is displayed on the screen.
Screen output:
• The VPS tests the CPU card, the flash memory, and the ports
• Active ports are displayed on the screen.
Screen output:
The display will alert you if System Setup is not completed successfully.
Screen output:
This message is shown when the digital (APT) connection between the VPS and
telephone system cannot be established.
Installation Manual
Checking Flash Memory Cards.
Please wait...
PORT TEST...
SYSTEM SETUP
1... 2... 3...
until "1...2...3..." is displayed.
Active COs: 1 2
APT Interface Connection is Established
** ON LINE MODE **
Active COs: 1 2
APT Interface Connection is not Established
** OFF LINE MODE **
63