Loading New Or Saved Data To The Vps (Load) - Panasonic KX-TVP50 Installation Manual

SYSTEM MAINTENANCE AND TROUBLESHOOTING

7.2.8 Loading New or Saved Data to the VPS (LOAD)

Use the LOAD command to install new data or to restore saved data to the VPS. Execute this
command for each data file.
When performing this operation, always wait until the process completion indication appears
before proceeding.
1.
Type LOAD, then Press RETURN.
$ LOAD
VPS Flash Memory Data Load (PC -> VPS : Xmodem)
1: Program
2: Parameters
3: System Prompts
4. User Prompts-1
5. User Prompts-2
6. Custom Service Menus
7. Personal Greetings
8. Company Greetings
Select No.:=
2.
Select the item to be restored to the flash memory, then Press RETURN.
To start press 'RETURN'
3.
Press RETURN.
- - - - - - LOAD Start!!
When "CCC" appears, the VPS is ready for loading.
4.
Set the data terminal to the sending (Call) mode (Xmodem). Then enter the backup
filename. Press ENTER. The backup data will be restored to the flash memory.
5.
When the load to the VPS has been completed, power-off and restart the VPS.
Notes
• The data terminal that you use must be equipped with communications software that
supports the Xmodem file transfer protocol. The command can be cancelled by Typing
[\] before entering the sending mode. Once the sending mode has been selected, use
the cancel command of the communication software being used.
• If your data terminal supports a high speed, it is recommended that you LOAD at the
maximum speed of 38400 bps. First, change the RS-232C setting of the VPS (see
B7.1 RS-232C Parameters). Next, change the RS-232C setting of your data terminal
to the same speed.
134 Installation Manual