Panasonic KX-TVP50 Installation Manual page 59

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
Intercom Paging*
Caller Name Announcement
(System/Personal)*
Caller ID Call Routing*
Personal Greeting for Caller ID* Each subscriber can record up to 4 personal greeting
Time Synchronisation
(DPT Integration only)
*
Note
Depending on the model and/or the software version of the connected PBX (see 3.1.1 APT/
DPT or Inband Signalling?), you may not be able to utilise some of the features listed above.
For more information, consult your dealer.
Installation Manual
DIGITAL INTEGRATION FEATURES
Caller ID Note 1: When an incoming outside call reaches the VPS via the
PBX, the VPS will wait about 2 rings before answering the call to receive the
Caller ID information properly from the PBX.
This waiting time can be changed by using the WCID command (see
7.2.20 Wait for Caller ID (WCID) in 7.2 UTILITY COMMANDS).
Caller ID Note 2: In the documentation for the KX-TD816/1232 series PBX,
the Caller ID feature is called CLIP (Calling Line Identification
Presentation).
Table 13
Callers can page subscribers through built-in speakers
and external paging equipment. For a Caller ID Caller,
if his name has been recorded for the Caller Name
Announcement feature, the name will be announced at
the end of the page.
The VPS announces the prerecorded Caller ID callers'
names when: (1) extension users listen to messages
from assigned numbers left in their mailboxes, (2) the
VPS transfers calls from assigned numbers to the
users, and (3) the VPS pages the users by intercom.
If the same Caller ID number is programmed for both
system and personal caller name announcements, the
VPS will use the personal caller name.
The VPS automatically sends calls from pre-assigned
Caller ID numbers to the desired extension, mailbox
or Custom Service.
messages for special callers.
Whenever the PBX sets a new date and time or when
DPT Integration is established, the data is
automatically registered in the VPS.
59