Vent System; Glass Door; Logs; Rock Wool - Vermont Castings 300DVB(N/P)(V/SC)7SB Installation And Operating Instructions Manual

Dvb series direct vent gas fireplace
Table of Contents

Advertisement

CLEANING and MAINTENANCE

VENT SYSTEM

The fireplace and venting system should be inspected
before initial use and at least annually by a qualified
field service person. Inspect the external vent cap on a
regular basis to make sure that no debris is interfering
with the airflow. Inspect entire venting system to ensure
proper function.

GLASS DOOR

Thoroughly clean the inside of the glass door after using
the fireplace for ten hours. Periodically clean the glass
door as necessary.
When cleaning the glass, remember:
• Do not remove the glass when hot. Allow glass to
cool before removal.
• NEVER use abrasive materials.
• Keep children and pets a safe distance away.
• Never operate the fireplace without the glass door
properly secured and the safety screen barrier in
place.
• Never operate the fireplace if the glass is broken.
• Replace any glass that is chipped, cracked, or broken.
Replacement glass door assemblies MUST be sup-
plied by the fireplace manufacturer – No substitute
materials may be used.
• Handle glass door with care to avoid striking or scratch-
ing it on hard objects.
To clean glass door, follow "Glass Removal" procedure
outlined in the Final Installation section. Film deposit on the
inside of the glass should be cleaned off using a nontoxic,
non-corrosive, non-abrasive, mild-cleaning solution. Simply
apply an adequate amount to the glass and wipe off with
a damp cloth. After all maintenance has been completed,
re-install glass door and re-install the safety screen barrier.
20306740
DVB Series Direct Vent Gas Fireplace

LOGS

Leave logs installed in the fireplace for cleaning. Vacuum
surface of the logs with a brush attachment. If logs must
be removed for cleaning, handle carefully by holding gently
at each end. Gloves are recommended to prevent skin
irritation from ceramic fibers. If skin becomes irritated,
wash gently with soap and water. Vacuum surface of logs
with brush attachment or brush logs with a soft bristle
brush (i.e. clean, dry paintbrush). To place logs back in
the fireplace, refer to "Log Placement" found in the Final
Installation section.
NOTE: Do not use fluids to clean ceramic fiber logs.

ROCK WOOL

Replace or add rock wool as required following installation
instructions in the Final Installation section of this manual.
45

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents