Download  Print this page

GE 03 Installation Instructions Manual page 8

Hide thumbs
   

Advertisement

ADDING DUCT FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the 4" straight duct in the elbow end hanging
out of the dryer bottom. Wrap duct tape around the
joint.
CAUTION:
Be sure not to pull or damage the
ADDING COVER PLATE TO REAR OF CABINET
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate
WARNING -
THE BACK OPENING WITHOUT THE
CHANGING DIRECTION OF DOOR OPENING
hinges. With the door completely open, remove the
bottom screw from each hinge on the dryer face. Insert
these screws about half way into the TOP holes, for each
REMOVE 4 PLUGS AND KEEP
FOR INSERTION INTO
THE OPPOSITE SIDE
2. Loosen the top screw from each hinge on the dryer face
half way. With one hand holding the top of the door and
the other hand holding the bottom, remove the door
from the dryer by lifting it UP and OFF.
Installation Instructions
PL ATE
(KIT WE1M454)
NEVER LEAVE
REMOVE BOTTOM SCREW FROM EACH HINGE
TOP OF
OPPOSITE HINGE HOLES
LOOSEN EACH TOP HINGE
THE DOOR UP AND OFF
3. Remove the blind plate from
the hinge side of the dryer
by removing its two screws.
Remove the strike plate from
the opposite side of the dryer
by removing its two screws.
Reinstall the plates, on the
opposite sides, using two
screws in each plate.
4.
side of the opening by moving the door ON and DOWN
until the top hinge and the bottom hinge are resting on
5. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the
two top screws on each hinge. Reinsert the plastic plugs
on the side from which the door was removed.
SCREWS AND TIGHTEN TOP
SCREWS
SERVICING
-
WARNING
TO DISCONNECTING WHEN SERVICING
IMPROPER AND DANGEROUS OPERATION
Please go to www.GEAppliances.com or mail in
your product registration card.
SWITCH
STRIKE
PLATE
FRONT PANEL
IT ON TOP HINGE SCREWS
INSERT PLUGS
INTO HOLES ON
OPPOSITE SIDE
LABEL ALL WIRES PRIOR
BLIND
PLATE

Advertisement

loading

  Also See for GE 03

  Related Manuals for GE 03