Page 2
Safety Information Follow these instructions to complete the installation of the AXIS 215 PTZ-E network camera. Warning! High voltage - the electrical connection must be made by an authorized electrician. Please observe relevant national and local regulations for the installation.
This guide provides instructions for installing this product. For all other aspects of using the product, please see the Installation Guide for the AXIS 215 PTZ network camera included in this package, and the user’s manual for the AXIS 215 PTZ network camera available from www.axis.com/techsup...
1. Place the AXIS 215 PTZ-E network camera on a clean, solid surface. 2. Loosen the four screws holding the dome (using the 3-mm allen key). Make sure the o-ring on the screw is in place.
- L, N, and GND. 2. Connect the camera to the network using the 5m CAT5E network cable. Please refer to the Assign an IP address chapter in the AXIS 215 PTZ installation guide to assign an IP address to the camera.
Page 9
• Installing the cables for audio and I/O must be done only by an authorized technician. • Installing audio and I/O cables will nullify the IP-66 rating and AXIS 215 PTZ-E Network Camera will no longer be suitable for outdoor use.
Page 10
Page 10 AXIS 215 PTZ-E Installation Guide 4. Remove the top by unscrewing 3 screws. 5. Remove the dome by loosening the 4 screws. 6. Remove the black (fan-and- heater) ring by unscrewing 4 screws. 7. Pull the I/O or audio cable through the casing and cable gland to the camera connection.