Pride CELEBRITY XL DELUXE Owner's Manual page 36

V I I . D I S A S S E M B L Y
5. Unplug the front-to-rear and rear lighting harnesses by
squeezing the sides and pulling straight up. See figure 22.
6. Unplug both battery harnesses. Pull each harness
straight up. See figure 22.
7. Unfasten the battery tie-down strap and remove the
batteries from the battery wells.
WARNING! Failure to unplug both
battery harnesses, the front-to-rear
harness, and rear lighting harness
prior to separating the front and rear
sections could result in permanent
damage to the scooter.
Handbrake Cable Disconnect
1. Locate the quick disconnect body. See figure 23.
2. Pull the quick disconnect handle back from the quick
disconnect body.
3. Position the quick disconnect handle over the top of the
quick disconnect body.
4. Separate the brake cable from the cable clamp located
inside the quick disconnect body. See figure 24.
Frame Separation
1. Squeeze the tiller adjustment lever and lower the tiller
to its lowest point.
2. Lift up on the frame release lever. See figure 25.
3. Lift the front section up until the frame hooks of
the front section separate from the rear section.
See figure 26.
NOTE: Stabilise the rear section with your free hand
by holding onto the upper frame tube. See figure 26.
4. Slowly separate the two sections. See figure 26.
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 26.
2. Use the frame release lever to lift the front section as
you align the frame hooks of the front section with the
lower frame tube of the rear section. See figure 25.
3. Once the frame hooks are over the lower frame tube,
lower the front section completely. This will engage
the frame lock. See figure 25.
4. Raise the tiller.
36
A N D
REAR LIGHTING
HARNESS
BATTERY HARNESSES
Figure 22. Harness Connections
Figure 23. Quick Disconnect Handbrake Cable
Figure 24. Handbrake Cable Release
www.pridemobility.com
A S S E M B L Y
FRONT-TO-REAR HARNESS
QUICK DISCONNECT HANDLE
QUICK
DISCONNECT
BODY
Celebrity XL Deluxe