Disassembly And Option Instructions - Icom IC-M1V Service Manual

SECTION 3
• Removing the Rear panel
A
Rear panel
Front panel
A
(2 × 20 mm), and 4 screws
Unscrew 2 screws
B
(2 × 5 mm, black) from the rear panel.
NOTE : Once the front panel is removed, grease must be
applied to areas before assembly.
Manufacture : Shin-Etsu Chemical
Type : G-501
• Removing the RF unit
VR unit
Connector cap
Knob
G F
H
I
J
q Remove connector cap.
w Remove 2 knobs, and unscrew 3 nuts (
D
(2 × 3.5 mm, silver), and 2 screws
e Unscrew 3 screws
E
(2 × 5 mm, black) from the RF unit.
J
(2 × 5 mm, black), and remove 1
r Unscrew 1 screw
I
washer .
t Take off the RF unit in the direction of the arrow.

DISASSEMBLY AND OPTION INSTRUCTIONS

B
J2
B
Rubber
E
D
RF unit
F G H
, , )
• Removing the MAIN unit
C
J1
Rear panel
q Unscrew 7 screws
the MAIN unit.
w Unplug J1 to separate the rear panel and the
MAIN unit.
• Install the optional unit (UT-98 or UT-112) to the
connector (MAIN unit ; J3)
MAIN unit bottom view
CAUTION :
DO NOT guarantee the waterproof construction when
installing the optional unit except distributors or dealers.
3 - 1
J1
C
C
MAIN unit
C
(2 × 3.5 mm, silver) from
UT-98 or UT-112
J3