Table of Contents
Advertisement
5.2
Error Conditions
If there is error during scanning, the LED light will be flashing in red color and error codes
will be displayed. Refer to the following table to clear the error conditions.
Error
Code/Meaning
E03
Storage error
E04
Paper jam
E05
No image scanned
E06
Cover opens
E08
Low battery
E19
Calibration Fails
* Warning:
If "low battery" is indicated on the LCD display, it is recommended to recharge the battery to
prevent possible incomplete scanned images or other operational problems.
Cause
Storage is full; can not save
image to storage device.
Storage device not recognized.
1. Original has become stuck in
the feeder.
2. Original exceeds max. length
[300 dpi: 36" (914mm), 600
dpi: 14" (356mm)]
No scan data detected.
Feeder cover opens.
Battery power getting low.
Internal check failed and found
calibration data error
How to restore
Free more space or insert a new
SD card.
Format your storage device.
Open the feeder cover and pull
the original out of the feeder.
Wait until error disappears.
Close the feeder cover.
Recharge the battery.
Recalibrate the scanner (see the
"Calibrate Scanner" section.
5-2
Advertisement
Table of Contents
