Encore E4 Installation Manual
Professional 2-way lcd remote 4 channel alarm system
Hide thumbs
Also See for E4:
- Quick start user manual (2 pages) ,
- Operation manual (13 pages) ,
- User manual
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operating Manual
Advertisement
Table of Contents
Related Manuals for Encore E4
Summary of Contents for Encore E4
-
Page 1: Installation Manual
PROFESSIONAL 2-WAY LCD REMOTE 4 CHANNEL ALARM SYSTEM INSTALLATION MANUAL This unit is designed for professional installation only and must be installed by an Encore authorized dealer. Please register this product at www.encoreautomotivesystems.com. E4 IN REV. A... - Page 2 Install the wiring neatly under carpets or behind trim to prevent possible damage to wires. FOR AUTHORIZED DEALER TECHNICAL SUPPORT, PLEASE CALL Toll Free: (855) GO-ENCORE : 8:00 am TO 5:00 pm PST. E4 IN REV. A...
- Page 3 INSTALLATION DIAGRAM E4 IN REV. A...
- Page 4 RED : FUSED 12 VOLT (+) BATTERY POWER BLUE / BLACK: (-) HORN OUTPUT 3 PIN, DOOR LOCK CONNECTOR ( - ) Unlock Pulse 1. Blue Wire (+) Lock Pulse ( - ) Lock Pulse 3. Green Wire ( + ) Unlock Pulse E4 IN REV. A...
- Page 5 - Remove the protective tape backing. - Carefully align the two-way transceiver/antenna and apply to windshield. - Route the black connector wire behind the trim and connect to the two-way transceiver/antenna. - Connect the other end to the control module. E4 IN REV. A...
- Page 6 Upon disarming, the interior lights will remain on for 30 seconds. b). If the alarm is triggered, the interior light will flash for the same duration as the siren. E4 IN REV. A...
- Page 7 This wire is the ground trigger input wire for negative door pin switch. This wire is connection for "grounding" type factory door pins locate the "common wire" that connects the door pin switches. Make the connection of the GREEN Wire here. E4 IN REV. A...
- Page 8 "0 volt". Move the alligator clip to +12V and the voltmeter will receive "12 volts". Cut this wire and make connections. Be sure to program Blue Wire door lock timer to 3.5 seconds. (See Alarn Feature B – 3 Programming.) E4 IN REV. A...
- Page 9 4. If you have additional transmitters (up to 4) that need to be programmed, repeat step 3 for each transmitter. Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit. E4 IN REV. A...
- Page 10 Some vehicles turn on the dome light when ignition key is turned off. After remote start, with alarm on, a false alarm may occur when the run time elapses and the dome light comes on. To prevent this from happing, program Alarm Feature A-8 to “With Dome light turns on after ignition off (45 second door by-pass)”. E4 IN REV. A...
- Page 11 5 to 7 seconds and the window will close directly. If your vehicle has the “COMFORT feature” and you wish for the door to be locked and the window to be closed automatically at the same time by remote control, you can set the alarm feature “B-3 “with comfort feature”. E4 IN REV. A...
- Page 12 Changing the value will adversely affect operation and may cause damage. Note 2: Latched output = The latched output selection will send a negative signal as soon as the Channel 3/4/5 button is pressed and will continue until the button is pressed again. E4 IN REV. A...
- Page 13 Encore Automotive Systems LLC. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery. Your Encore equipment is guaranteed for “life” to the original purchaser/user of the equipment and the original vehicle in which it was installed by an authorized installer under the following conditions: If the product proves defective (according to Encore’s testing) within the first year, the defective unit may be exchanged or repaired free of charge.
- Page 14 **IMPORTANT NOTE: Any damages resulting from an installation performed by anyone other than a professional installation technician authorized by Encore will void the product’s Limited Lifetime Warranty It is the purchaser’s responsibility to register this product for any future warranty service.