Table of Contents
Advertisement
STEP 7
CONNECT TO WATER SUPPLY
The Installation Diagram shows an overview of the water
supply connection including the Pressure Limiting Valve.
• T he 350kPa pressure
limiting dual check
valve (PLVDC) must be
connected to the stop tap
as shown. Use plumbing
tape to create seal.
• U se plumbing tape to
connect the ¼" mbsp
to ¼" tube pushfit
connector to the PLVDC
STEP 8
CONNECT DUAL FAUCET TO WATER SUPPLY (IF FILTER SYSTEM NOT INCLUDED)
• T ake blue tube from Dual Faucet and insert into the tube connector at the end of the PLVDC as shown
in Step 7.
• P ull back on the tube to ensure tube is locked into position.
• C onnect red locking clip where shown in Step 7.
• T ubing must not be kinked or twisted.
• T ubing should be cut to a convenient length but should not be stretched taut.
• E nsure all fittings and tube connections are protected against damage from objects stored in the
cupboard.
STEP 9
INSTALL FILTER SYSTEM (IF INCLUDED) REFER INSTALLATION DIAGRAM
• T he filter system should be installed in a convenient location. Please allow 40mm clearance
underneath the filter to facilitate filter replacement.
• L ocate the head assembly and affix to kitchen cupboard with screws and bracket supplied.
• T he head assembly has 'pushfit' fittings on the inlet and outlet. Remove the red locking clips.
• T ake the length of blue tubing supplied and cut to size to connect from the outlet of the filter head to
the PLVDC. Make sure tube is cut square and clean with a Stanley knife or similar.
• T ake blue tubing from the dual faucet and insert in the outlet (right hand side of filter head) of filter
head assembly. Push tubing in and then pull back to ensure a tight seal. Reconnect locking clip.
• Water flow must be in the direction indicated by the arrow on the top of the filter head.
• I nsert filter cartridge into filter head - twist cartridge a quarter turn anti clockwise until cartridge
locks firmly into filter head.
Pressure Limiting
Stop tap for cold water
supply (not included)
Dual Check
Valve 350kPa
¼" mbsp x ¼"
tube connector
Locking clip
Advertisement
Table of Contents
