Troubleshooting - Sony DWR-S01D Operating Instructions Manual

Troubleshooting

If you encounter a problem using this receiver, use the following checklist to find a solution.
For any problems with the transmitter or adapter, refer to the operating instructions supplied
with the respective device. If the problem persists, consult your Sony dealer.
Symptom Meanings
The receiver The receiver is not correctly
does not turn inserted into the slot of the
on. camcorder or the optional DWA-
01D digital wireless adapter.
There is no The channel setting on the
sound. transmitter is different from that
on the receiver.
The transmitter is turned off.
The setting of the encrypted
transmission function on the
receiver is different from that on
the transmitter.
When the receiver is attached
through the optional DWA-01D
digital wireless adapter, the
setting of the sync signal is not
appropriate.
The sound is The attenuation level on the
weak. transmitter is too high.
The AES/EBU reference output
level is set to –36 dBFS LINEAR.
There is The attenuation level of the
distortion in transmitter is zero or too low.
the sound.
A LINE level signal is being input
while the input level of the
transmitter set to MIC.
Remedy
Insert the receiver until it is firmly
and completely in, and then secure
it with the mounting screws.
Use the same channel setting on
both the transmitter and receiver.
Check the power supply or battery
of the transmitter.
Confirm that the setting of the
encrypted transmission function is
the same on both the transmitter
and the receiver.
Using the sync signal selection
(SYNC SOURCE) function, set the
sync signal to INTERNAL.
When an external sync signal is
used, confirm the connection of the
sync signal, and set to AUTO or
EXTERNAL.
Set the attenuator on the
transmitter to an appropriate level.
Set the reference output level
according to the use (see page 20).
The input level of the transmitter is
extremely high. Adjust the
attenuation level on the transmitter
so that there is no distortion to the
sound.
Refer to the operating instructions
supplied with the transmitter and
set the input level to LINE.
Troubleshooting 31