Sony DWR-S01D Operating Instructions Manual page 26

switch on tuner 1 or tuner 2 to ON while
holding down the – button to pair the
transmitter with the tuner that you turned
ON.
1
Press the MENU SELECT button
repeatedly until the TX1/2 menu is
displayed.
2
Press the + or
the RF REMOTE indication is
displayed.
3
Hold down the SET button until the
item to be set flashes.
4
Press the + or
select PAIRING.
5
Press the SET button to enter the
setting.
Before proceeding to the next step, set
the transmitter to be controlled to
pairing mode.
For details, refer to the operating instructions
supplied with the transmitter.
The receiver starts searching for a
transmitter and then displays the
transmitter name with which pairing
can be executed.
During the search, pressing any
operation key on the receiver will
cancel pairing mode.
6
Press the + or – button repeatedly to
select the transmitter to be paired with
from among those indicated.
7
Press the SET button to enter the
setting.
The receiver starts to communicate
with the selected transmitter and the
wireless remote control condition
appears in the display. The condition
level (indicated by
26 Using the Wireless Remote Control Function
button repeatedly until
–
button repeatedly to
–
) goes up and
the remote control function becomes
operative.
Wireless remote control
condition indication
Note
If the receiving channel (CH) configured on
the receiver is a channel for which use with
the wireless remote control function is
restricted on the transmitter side, the
UNMATCH screen appears.
In such cases, change the receiving channel
on the receiver. If you want to use the
restricted channel, set REMOTE to OFF in
the transmitter's menu to release the
channel restriction, and manually configure
the transmitter's channel.
On wireless remote control
condition indication
Indicates the signal transmission condition
of the wireless remote control function (4
levels).
: Good transmission
: Somewhat good transmission
: Somewhat poor transmission
: Poor transmission
: Unable to communicate with
paired receiver
When the wireless remote control function
is off, this indication does not appear.
Using the wireless remote
control function with a
previous pairing
With the TX1/2 menu, select RF REMOTE,
and then select ON.