Troubleshooting - Sony R-D-S EON STR-D365 Operating Instructions Manual

14°
V:Vo foliureysl-) Mistielattciile)s|
Le ee ge |
Troubleshooting
If you experience any of the following difficulties while
using the receiver, use this troubleshooting guide to
help you remedy the problem. Should any problem
persist, consult your nearest Sony. dealer... _-
There's no sound or only a very low-level sound is heard.
=> Check that the speakers and components are
connected securely.
=> Make sure you select the correct component on
the receiver.
=> Make sure you set the SPEAKERS selector
correctly.
=> Press MUTING if the MUTING indicator turns
on.
=> The protective device on the receiver has been
activated because of a short circuit.
("PROTECT" flashes.) Turn off the receiver,
eliminate the short-circuit problem and turn on
the power again.
The left and right sounds are unbalanced or reversed.
"> Check that the speakers and components are
connected correctly and securely.
=> Adjust the BALANCE control.
Severe hum or noise is heard.
=> Check that the speakers and components are
connected securely.
=> Check that the connecting cords are away froma
transformer or motor, and at least 10 feet (3
meters) away from a TV set or fluorescent light.
> Place your TV away from the audio
components.
Make sure you connect a earth wire to the aerial
earth terminal.
=> The plugs and jacks are dirty. Wipe them with a
cloth slightly moistened with alcohol.
4
RDS isn't working.
=> Make sure you're tuning an FM station.
=> Select a stronger FM station.
The appropriate display or information does not appear.
=> Contact the radio station and find out whether
or not they actually provide the service in
question. If so, the service maw be temporarily
out of service.
The station, or programme source, was interrupted by
another station / the tuner automatically starts searching
stations.
=> The EON function is working. Turn off EON
when you don't want the current programme
interrupted.
The station name does not appear in the display.
=> Press DISPLAY until the station name appears.
Radio stations cannot be tuned in.
=> Check that the aerials are connected securely.
Adjust the aerials and connect an external aerial
if necessary.
=> The signal strength of the stations is too weak
(when you tune in with automatic tuning). Use
direct tuning.
=> No stations have been preset or the preset
stations have been cleared (when you tune in
with scanning preset stations). Preset the
stations (see page 10).
Recording cannot be made.
=> Check that the components are connected
correctly.
The remote does not function.
"=> Point the remote at the remote sensor El on the
receiver.
=> Remove the obstacles in the path of the remote
and the receiver.
=> Replace both batteries in the remote with new
ones if they are weak.
=> Make sure you select the correct function on the
remote.
After turning off the power with the remote, you can't turn
the power back on because you lost the remote.
=> Press POWER on the receiver while holding
down the TUNER button.