Manual Freewheel Lever; Safety Flag Bracket - Pride Celebrity DX Sport Owner's Manual

Manual Freewheel Lever

Whenever you need or want to push your scooter for short distances, you can put it in freewheel mode.
1. Remove the key from the key switch.
2. Push forward on the manual freewheel lever to disable the drive system and the brake system. You may now
push your scooter.
3. Pull back on the manual freewheel lever to reengage the drive and the brake systems and take your scooter out
of freewheel mode.
WARNING! When your scooter is in freewheel mode, the braking system is disengaged.
! Disengage the drive motors only on a level surface.
! Ensure the key is removed from the key switch.
! Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on
a scooter to do this.
! After you have finished pushing your scooter, always return it to the drive mode to lock
the brakes.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in
the "on" position, the scooter will not run until the manual freewheel lever is pushed rearward and the
key is turned to the "off" position, then back to the "on" position.

Safety Flag Bracket

An accessory bracket for installing an optional safety
flag is mounted near each anti-tip wheel. To install the
flag, the supplied "L" shaped hex key is needed. See
figure 8A.
To install the flag bracket:
1. Remove the cap from the top of the bracket.
2. Loosen the setscrew with the supplied "L"
shaped hex key.
3. Insert the flag pole into the opening.
4. Tighten the setscrew to complete installation.
Celebrity DX Sport
I V . Y O U R
www.pridemobility.com
S C O O T E R
Figure 8A. Safety Flag Bracket
HEX KEY
CAP
SETSCREW
21