Table of Contents
Advertisement
ARS-2018/2018E Manual
3.2
Scan Disk 1 : scan the upper hard drive
It is to scan if the upper hard drive is all right. While scanning, the system
will ask if you want to continue scanning when it detects a failed track in the
hard drive. Once this function is triggered, the menu will change to "Stop
scan disk1" automatically so that the system administrator can stop
scanning.
3.3
Scan Disk 2 : scan the lower hard drive
It is to scan if the the lower hard drive is all right. While scanning, the
system will ask if you want to continue scanning when it detects a failed
track in the hard drive. Once this function is triggered, the menu will change
to "Stop scan disk2" automatically so that the system administrator can
stop scanning.
3.4
Password : the setting of a password
3.4.1 Enable password : enable the password protection
Once you activate the password, the system will ask you to key in the
password.
3.4.2 Change password : set a new password
Key in the old password, then key in a new password, and confirm the
new password once again to finish the change. If you don't activate
the password protection, the function will be hidden.
3.5
Advanced status : the condition of the system
It is to display the scanning or rebuilding or comparing progress.
The progress will be displayed in standby mode, too. If there is nothing
proceeding in the system, the function will be hidden.
3.6
Remove Disk 1 : safely remove the upper hard drive (for mirror mode only)
3.7
Remove Disk 2 : safely remove the lower hard drive (for mirror mode only)
3.8
Mirror size : set the Mirror capacity
3.8.1 Set maximum : set the maximum capacity
3.8.2 Extend size : extend the size of Mirror
When the two hard drives of the original system have been changed,
and the capacity is bigger than the previous mirroring size, you are allowed
to execute this function to extend the size of Mirror. The newly increased
capacity will be indicated as the second partition.
24
Advertisement
Table of Contents
