ACARD is the trademark of ACARD Technology Corp. Microsoft and the Windows Logo are the registered trademarks, and Windows is thetrademark of Microsoft Corporation. All brands and trademarks are the properties of their respective owners.
Table of Contents Chapter 1.About SCSIDE II.........................7 Chapter 2.Introduction..........................8 2.1.Overview...........................8 2.2.Features.............................8 2.3.Specifications..........................8 2.4.Package and Others........................9 Chapter 3.Hardware Installation......................10 3.1.Install a 2.5'' HDD........................10 3.2.Set the Jumper.........................12 Chapter 4.Troubleshooting.........................13 Chapter 5.Technical Support Form.....................14...
Page 5
Member nations already established their free of charge recycle systems of WEEE before August 13, 2005. Accordingly, ACARD has to be responsible for recycling all products exported to Germany. You can return your ACARD product that needs recycling to a local collector.
Page 6
WEEE,. De ce fait, Acard est responsable du recyclage de tous les produits exportés vers l’Allemagne. Vous pouvez mettre au rebut votre équipement ACARD usagé dans votre centre local de recyclage.
SCSIDE II are more practical and more popular. Besides having the new functions of ACARD’s IC, the series products of SCSIDE II contain the technology of the first generation, too. In operation, SCSIDE II uses the built-in RISC...
Chapter 2. Introduction 2.1. Overview ARS-2000SUP is a SCSI-to-SATA II bridge. Through its connection to a SCSI host 50-pin connector the bridge can turn a 2.5'' hard drive into a 50-pin single ended SCSI HDD. Thus, you can replace old/damaged SCSI HDD by the bridge with high performance and cost-effective SATA HDD.
2.4. Package and Others • Package ◦ ARS-2160 or ARS-2320 × 1 ◦ screws for 2.5” SATA hard drive × 4 ◦ screws for ARS-2160 or ARS-2320 × 4 ◦ User's manual × 1 • Spec Parameters ◦ Temperature: Operation: 0° C to 85° C ◦...
1. Remove the 4 screws of ARS-2000SUP and open the upper case. 2. Slide the 2.5'' SATA hard drive along the sides of ARS-2000SUP till it connects CN16. 3. Fix the SATA hard drive to the two sides of ARS-2000SUP with the enclosed 4 screws.
Page 11
4. Return the upper cover of the bridge and fix with the 4 screws.
Chapter 4. Troubleshooting After installing ARS-2000SUP, if it doesn't work properly, try to eliminate the problem referring to the procedures below: 1. Check the hardware installation a. Make sure SATA HDD was firmly connected to the ARS-2000SUP. b. Make sure the ARS-2000SUP was firmly connected to the SCSI cable.