Lighting Instructions - Napoleon LEX 485 User Manual

Lighting Instructions

Lights
WARNING!
Open lid.
WARNING!
Ensure all burner controls are in the off position. Turn on the gas supply
valve.
Main Burner
Lighting
1. Open grill lid.
2. Push and turn any main burner
knob slowly to the 'hi' position. This
action will ignite the pilot flame
which will in turn light the selected
burner. If the pilot lights, continue to
push down on the control knob until
the burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
step 2 several times.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
or light with a match.
5. If lighting the unit with a match,
clip the match into the supplied
lighting rod. Hold the lit match down
through the grill and sear plate while
turning the corresponding burner
valve to high.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use the rear burner (rotisserie burner) with the main burners operating.
Left Rear Infra Red
Centre
Burner Burner
Burner
Burner
Rear Burner Lighting
(Rotisserie Burner)
(if equipped)
1. Open grill lid.
2. Remove the warming rack.
3. Push and turn the rotisserie burner
control knob slowly to the 'hi' position.
This action will ignite the pilot flame
which will in turn light the burner. If
the pilot lights, continue to push down
on the burner control knob until the
burner lights then release.
4. If the burner does not ignite, then
immediately turn the control knob back
to the 'off' position and repeat step 3
several times.
5. If the burner will not ignite within
5 seconds, turn the control knob to
the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 3 and 4 or light with a
match.
Side Burner
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner
control to high position.
3. Press and hold igniter button
until burner lights, or light by
match.
4. If the burner will not ignite
within 5 seconds, turn the control
knob to the 'off' position and wait
5 minutes for any excess gas to
dissipate. Either repeat steps 2
and 3 or light with a match.
www.napoleongrills.com
9