Using The Wps/Wlan Button; The Reset Button; Using The Reset Button - ZyXEL Communications eircom D1000 User Manual

1.4.3 Using the WPS/WLAN Button

By default, the wireless network on the Device is turned on. To turn it off, simply press the WPS/
WLAN button on top of the device for over 5 seconds. When the WPS/WLAN LED is green, the
wireless network is active.
You can also use the WPS/WLAN button to quickly set up a secure wireless connection between
the Device and a WPS-compatible client by adding one device at a time.
To activate WPS:
Make sure the POWER LED is on and not blinking.
1
Press the WPS/WLAN button for 1-5 seconds and release it.
2
Press the WPS button on another WPS-enabled device within range of the Device. The WPS/WLAN
3
LED should flash while the Device sets up a WPS connection with the other wireless device.
Once the connection is successfully made, the WPS/WLAN LED shines green.
4

1.5 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the side panel of the device to reload the factory-default configuration file. This means
that you will lose all configurations that you had previously and the user name and password will be
reset to the default.

1.5.1 Using the Reset Button

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
eircom D1000 modem User's Guide
Chapter 1 Introduction
15