Table of Contents
Advertisement
1.Specifications
Cable Required: Category 5 shielded or unshielded twisted pair (STP or UTP)
Compliance: CE; FCC Class A, IC Class/class A
Video Support: Composite to 2048x1536, transmitter/receiver dependent
Video Resolution and
Refresh Rate:
Transmitter/Receiver dependent. See specifications for
transmitter/receiver used
Audio Modes:
Transmitter/Receiver dependent. See specifications for
transmitter/receiver used
Serial transmission
Modes:
Simplex (broadcast) transmit only –requires appropriate
transmitter/receiver combination
Maximum
Distance:
Total end to end, from source device to farthest destination
device, over good CAT5 cable to 1,500 ft (457m)
(Receiver dependent )
Connectors:
(16) RJ-45 input, (16) RJ-45 output, (1) captive screw phoenix;
(1) power DIN
Front Panel Control: (16) input buttons, (16) output buttons, (4) control buttons
Serial\ Control: RS-232, 7-bit ASCII: 8 data bits, no parity, 1 stop bit, 9600 bps
via phoenix connection
Temperature
Tolerance: Operating: 32 to 104°F (0 to 40°C);
Storage: -4 to +140°F (-20 to +60°C)
Humidity
Tolerance: Up to 80% noncondensing
Enclosure: Steel
Power: 24VDC @ 2.0A
Size: 3.50"H x 17.2"W x 6.8"D (8.7 x 43.6 x 17.2 cm);
Weight: 2.6 lb. (1.2 kg)
CHAPTER 1: Specifiations
5
CAT5 MULTI VGA SYSTEM
2. Introduction
2.1 Overview
The CAT5 Multi 16 x 16 Matrix Switch switches signals over Category 5
Cable to any number of 16 outputs.
This manual covers the CAT5 Multi 16 x 16 Matrix Switch. CAT5 Multi Video
System transmitter units as well as CAT5 Multi Video System receiver units are
required for operation. Please contact technical support for help.
WARNING
This equipment is not intended for, nor does it support, distribution
through an Ethernet network. Do not connect these devices to any sort
of networking or telecommunications equipment!
2.2 Package Contents
You should have received the following when ordering a CAT5 Multi 16 x 16 Matrix
Switch :
• The 16 x 16 Matrix Switch.
• Power cord.
• This manual.
2.3 Equipment You May Also Need
• Serial cable for external control.
• CAT5 cable.
2.4 Compatible Cabling
CAT5 cabling for the CAT5 Multi System must be pinned to the TIA-EIA
T568B wiring specification. We also highly recommend that all CAT5 cables
be pre-terminated and tested. Cables terminated on-site or in an existing
infrastructure should be tested before use to ensure compliance with the TIA-EIA
T568B specification. Using incorrectly terminated CAT5 cables can damage the
CAT5 Multi System.
6
.
Advertisement
Table of Contents
