Advertisement
9. TRANSPORTING/STORAGE
l spillage when transporting or during temporary storage, the genera-tor should be
secured upright in its normal operating position, When transporting the generator:
Do not overfill the tank (there should be no fuel in the filler
WARNING
neck)
Do not operate the generator while it is on a vehicle. Take
the generator off the vehicle and use it in a well ventilated
place.
Avoid a place exposed to direct sunlight when putting the
generator on a vehicle. If the generator is left in an enclosed
vehicle for many hours, high temperature in-side the vehicle
could cause fuel to vaporize resulting in a possible explosion.
?Do not drive on a rough road for an extended period with the
generator on board, if you must transport the generator on a
rough road, drain the fuel from the generator beforehand.
Before long while storag, the following items should be done:
(1) Run the generator for 5 minutes without any load.
(2) Drainage the oil and refill the new oil.
(3) Drainage the fuel to a clean container and clean the fuel tank.
(4) Clean the dirty in generator. Seal the generator with a plastic cover for safekeeping
in dry place.
Fuel is explosive and flammable. Smoke, fire and spark are
WARNING
forbidden.
-
-
1. For example LCD-230V
1---Genset output voltage (V); 2---Genset current with load (A);
3---Genset frequency (Hz);
4---Genset running time
5---Battery voltage.
Shift the parameters by the button
2. LCD-120V / 240V
(1) Output in parallel:
1---output voltage;
4---output current;
7---Running time;
8---Battery voltage;
(2) Output in series:
1---Sum of A, B phase voltage;
2---A phase voltage;
4---A phase current;
5---B phase current;
7---Running time;
8---Battery voltage;
3.1.3 Maintenance information
1. Maintenance will be reminded after specific running time. LCD lamp twinkles and the
codes will be displayed. If there is many codes, they may be displayed in turns at an
interval of 3 seconds if there is many codes.
Item
Maintenance information
1
Oil
2
Oil filter
3
Air filter
4
Nozzle pump
5
Valve clearance
6
Tank and filter
2. Press the button to read the parameters. Release the key for 2 seconds to have the
maintenance
Remind.
3. Press the button for 5 seconds to clear the maintenance information.
3.2 Instruction of energy saving switch:
Energy saving switch
When Energy saving switch locates the side of "OFF" the speed of engine varies
when output power varies. Power increases while speed increases. Engine will run
under the low speed without any load; the total machine will work in perfect economic
state.
When Energy saving switch locates the side of "ON" Engine will run under the max.
speed. Inverter module reaches max. power. This mode must be used during sudden
load and unload.
Code
Parameter
6---output frequency;
(2 3 5 are shielded)
3---B phase voltage;
6---output frequency;
Code
SV 1
SV 2
SV 3
SV 4
SV 5
SV 6
- -
Key
Hide quick links:
Advertisement
