Trouble Shooting - Kipor ID6000 Operation Manual

Output indicator lamp (Green)
Overload alarm lamp (Red)
Low oil level alarm lamp (Red)
Over speed alarm lamp (Red)
1. Socket
2. Breaker
3. LCD monitor
4. Lamp
5. Energy saving switch
6. Electric lock (start switch)
7. Earthing end
8. Socket
9. Reset switch
Single voltage panel
10. ATS option switch
3.1. LCD instruction:
Key
Screen
3.1.1 Instructions of dual voltage connector
Item Function Item
5 6 out external switch,
1 A phase AC voltage input 5
Series connection when closed
2 B phase AC voltage input 6
Parallel connection when open
3 A phase AC voltage input 7 A phase current transformer input
4 B phase AC voltage input 8 A phase current transformer input
3.1.2 Instructions of single voltage connector
Item Function Item
1 AC voltage input 4 Relay control signal output (+12v)
2 AC voltage input 5 Current transformer input
3 Current transformer input 6 Relay control signal output (GND)
Function Item Function
9 B phase current transformer input
10 B phase current transformer input
11 External battery GND
12 External battery 12V
Function Item Function
7 External battery GND
8 External battery 12V
9
- -

10. TROUBLE SHOOTING

When the engine will not start:
No
Is there fuel in the tank?
Yes
No
Is there enough oil in the engine?
Yes
No
Is the battery voltage 12 to 15V?
Yes
Take the generator to an authorized dealer.
The engine fails to run with load:
No
Is the output indicator lamp on
Yes
No
Is the AC breaker switched on?
Yes
Yes
Is the overload indicator lamp on?
Yes
Yes
Is the electric appliance in good condition?
Yes
Take the generator to an authorized dealer.
Refill the fuel tank.
Add the recommended oil.
Replace or charge the battery
Take the generator to an authorized dealer
Turn on the breaker.
Lower down the load or replace the generator for a larger one
Replace or charge the electric appliance
- -