Samsung SMT-W5100E Quick Setup Manual page 5

Hide thumbs Also See for SMT-W5100E:

4: Programming SMT-R2000

Note: It takes about 1 minute to reboot the SMT-R2000.

Set IP address of the PC to the same subnet address range of SMT-R2000.

a. Ex. Set PC to the following:

i. IP: 192.168.111.9

ii. SM: 255.255.255.0

Connect PC to the SMT-R2000 via LAN or WLAN

a. For LAN:

i. Connect a data cable to the LAN port of the SMT-R2000

b. For WLAN:

i. Factory default SSID is SMT-R2000-WLAN1 (802.11b/g)

Make sure the SMT-R2000 is in idle state. It takes about 1 minute from power on to idle

state. The following LED shows idle state.

a. WAN: ON

b. LAN: OFF

c. 2.4GHz: flashing

d. 5GHz: flashing

e. PWR: ON

Access the Web management page of the SMT-R2000 by using "Internet Explorer"

a. The default setting of SMT-R2000:

i. IP: 192.168.111.10

ii. ID: admin

iii. PW: samsung

b. Using "ping 192.168.111.10" to confirm the connectivity.

Select country code and click [Update]

Under [Basic Setting]

a. Optional

i. Time Compensation: -6(CH)

ii. Location: AP1 (or AP2, etc.)

b. Must change

i. IEEE 802.11b/g (SSID): 80211g

c. Click [Update]

Under [Manage],

a. [Ethernet Setting]

i. WAN Interface Settings

1. Current software version of WIP-5000M requires numeric SSID.

1. Static IP Address: 192.168.111.11 (Must use different address for

each AP)

01/2007