Accent Lamp - White Mountain Hearth DVX36FP32CLN-1 Installation Instructions And Owner's Manual

Your Luxury Direct Vent Gas Fireplace comes equipped with our
"Accent Lamp." The light has been pre-wired and is controlled
from the Rheostat.
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1. Unplug the Accent Lamp/transformer from the junction box
inside the fireplace.
2. Remove the four screws that secure the lens frame. This frame
retains the glass lens. The bulb can now be accessed.
Note: Do not handle the lamp (bulb) with bare fingers, protect
with clean dry cloth.
The lamp will pull straight out of the socket. Replace with 10
Watt/12 Volt Halogen bulb.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes
in the lamp housing are necessary for ventilation and must not be
covered.
12 VOLT SIDE
120 VOLT SIDE
Figure 74 - Accent Lamp Wiring
25047-0-0309

ACCENT LAMP

Figure 75 - Accent Lamp Parts
COVER
LAMP
GASKET
GLASS
BEZEL
Page 65